XTREME24 ALUMINUM KITS 3D PRINTED PRODUCTS You will need 4 ×

You will need 4 × M3 x 8mm screws to mount the 3D-printed pieces to the sliders (hardware not included)

WITH THESE YOU'LL HAVE ADJUSTABILITY TO LEAN YOUR SHOCKS AND DROOP THE FRONT OF YOUR RIG

YOU'LL BE ABLE TO RUN SMALL BATTERY ACROSS

COMPATIBLE WITH OUR X MOUNT AND LAY DOWN SERVO MOUNT

Available transmission hole patterns:

XTREME24 ALUMINUM KITS 3D PRINTED PRODUCTS You will need 4 ×Watch attached video for info on the one and two piece set up Built for serious performance, the XTREME24 chassis was designed to push your 1 24 build further. Featuring an aggressive 27 breakover angle, this chassis improves clearance over obstacles while reducing hang ups on steep transitions. Designed with multiple mounting points, the XTREME24 gives builders the flexibility to fine tune shock placement, link geometry, and overall setup to match